Frame ID Plate

Got the new frame ID plate (51 14 1 231 087) installed. I had used a Dremel to saw off the old rivets, then had the frame powder coated. In order to install the new ID plate, I used a 5/64" metal bit to drill through the old holes. Then, I just tapped the rivets in with a mallet.

Center Stand

After powder coating the frame, the first thing I did was attach the center stand. The old one was in bad shape, so I decided to buy a new /5 stand from Hucky's (46 52 1 230 201). The old bushings did not fit loosely in the holes on the new stand, no doubt because of the powder coating. I used a rounded file to file down the powder coating on the stand and that did the trick. The bushings should be a little loose and not snug in the holes. I added a little moly grease to the bushings as I installed them. I also used a little Blue Loctite on the threads to make sure the nuts won't come loose.

I also replaced the rubber bumper (46 52 1 231 815) with a new one.

Paint and Pinstriping

As the frame and other welded parts were being powder coated, I had sent the remaining metal and fiberglass components to a body shop for painting. Fitzgerald Body Shop (920.337.2222), also in Green Bay, had done some work for Nick's, our local BMW dealer, so they were familiar with these bikes. They handled not only the painting, but also did a beautiful job on the hand pinstriping, as you can see on the fenders.

The parts I had painted included the front and rear fenders, gas tank, headlamp bucket and headlamp bucket brackets. I had the body shop leave the pieces unbuffed for a higher shine.

Powder Coated Frame!

The black powder coated parts look fantastic. The powder coating shop I used is Spence Industries in Green Bay, WI (920.662.0720). If you're in this neck of the woods, I'd highly recommend them. They also topped off the powder coating with a high gloss protective coat. Thanks to Nick's BMW for the tip on Spence Industries. Now the reassembly can begin!

Draining the Fork Oil

Following the steps to drain the fork oil is a very simple process, but does require a special tool to loosen loosen the drain plug nut while at the same time using an allen wrench to hold the center (see photo). The fork drain tool is available from Joe's Tools. Loosen the nuts, then look out!

Front Fork Removal

The front wheel and forks were the last items removed from the motorcycle. I kept them as one unit, upright, until I was ready to drain the oil from the forks. When I finally removed the front wheel, I placed the axle back into the forks to keep track of the parts and also hold the forks steady.

I still kept the forks at a slight angle so the oil wouldn't leak out of the top. Then, I removed the two white dust caps at the bottom of the forks and followed the steps in Duane Ausherman's article to drain the oil.

Magura Grip Wedges!

When taking apart the handlebar control assemblies, be VERY careful not to lose the Magura grip wedges. These are tiny, rectangular pieces with ridges that prevent the assembly from rotating on the handlebar when tightened. Note that the one pictured has been cleaned. When you first take these apart, they may be black from age and hard to see, and can easily get lost. New ones (32 72 2 072 223) run about ten bucks each!